Air distribution

BDD
Back Draft Damper

  • Spring Loaded Backdraft Damper
  • Neoprene damper seal minimizes leakage
  • 20 gauge steel housing, aluminum spring loaded butterfly damper
  • Gasket designed to withstand temperatures from -22 F to 180 F
  • Requires from 0.04 to 0.08 in. wg pressure to open
  • Simple installation, entire assembly inserts into duct
  • Exterior foam gasket assures a tight seal against duct
  • 4’’, 5’’, 6’’,8’’ sizes include stamped metal sleeve with center pin design
  • 10’’& 12’’sizes include rolled metal sleeve with center post design

ADC
Duct Clamp

  • The ADC clamps are intended to simplify fan installation and isolate fan vibration from rigid metal duct.
  • ADC clamps are convenient in installations where regular removal of the fan is necessary for inspection and cleaning.
  • ADC clamps are available in sizes 4” through 16” to fit corresponding duct sizes.
  • ADC clamps in sizes 4” through 12” are equipped with integral hanging tabs.

ADA
Diffuser Adapter

  • Quick and easy installation with no sharp edges.
  • Can be used for ceiling or wall terminations.
  • Preset for 1/2 and 5/8-inch drywall. •90° back-stop for a level, uniform installation with bottom flange for a permanent air seal.
  • Off-set from joist for easy installation of ducting and clearance for application of tape or sealer.
  • Duct-Stop-Point ensures no screws penetrate the collar and impede the insertion of the grille.
  • A rigid bottom flange guarantees the drywall router tool conforms to the circular opening.
  • V-shaped indentations on bottom edge for centering with previously installed fixtures.
  • Available in 4’’, 5’’, 6’’

RAD
Round Adjustable Diffuser

  • Dual flow: whisper quiet air supply or exhaust with lock nut
  • To fine tune air flow from 0-100%
  • Strong stainless steel grip clip provides snug fit.
  • Extra thick foam gasket allows for tight seal on uneven
  • Surfaces and provides quiet air flow
  • Long-lasting durability with impact resistant, polymer resin.
  • WG401 vent is compatible with Primex’s squeeze elbow
  • Accessory EB4x90.
  • Easy to install and remove.
  • •Available in 4’’, 5’’, 6’’